保定隔离墩模具厂家

一、模具制造工艺流程如下：

1. The process flow of mould manufacturing is as follows:

审图—备料—加工—模架加工—模芯加工—电极加工—模具零件加工—检验—装配—飞模—试模—生产。

Review, map preparation, preparation, processing, mould frame machining, core processing, electrode processing, mold parts processing, inspection, assembly, flying mold, trial production.

02

02

二、模架加工细节

Two. The processing details of the mold frame

（1）打编号要统一，模芯也要打上编号，应与模架上编号一致并且方向一致，装配时对准即可不易出错。

(1) the number must be unified. The mold core should also be numbered. It should be consistent with the number on the mould frame and the direction is the same. Assembly alignment is not easy to make mistakes.

（2）A/B板加工（即动定模框加工）

(2) A/B plate processing (that is, moving die frame)

A/B板加工应保证模框的平行度和垂直度为0.02mm

A/B plate processing shall ensure that the parallelism and perpendicularity of the mold frame are 0.02mm.

铣床加工：螺丝孔，运水孔，顶针孔，机咀孔，倒角

Milling machine processing: screw holes, water holes, thimble holes, machine nozzle holes, chamfering.

钳工加工：攻牙，修毛边

Fitter processing: tapping and trimming

（3）面板加工：铣床加工镗机咀孔或加工料嘴孔。

(3) panel processing: milling machine processing boring machine nozzle or processing material hole.

（4）顶针固定板加工：铣床加工：顶针板与B板用回针连结，B板面向上，由上而下钻顶针孔，顶针沉头需把顶针板反过来底部向上，校正，先用钻头粗加工，再用铣刀精加工到位，倒角。

(4) top needle fixed plate processing: milling machine processing: the top needle plate and the B board with the needle link, the B board up, the top and down the top of the pinhole, the thimble head need to reverse the top of the top needle to the bottom, correction, the first use of drill bit rough machining, then milling cutters in place, chamfering.

（5）底板加工：铣床加工：划线，校正，镗孔，倒角。（注：有些模具需强拉强顶的要加做强拉强顶机构，如在顶针板上加钻螺丝孔）

(5) floor processing: milling machine processing: scribing, correcting, boring and chamfering. (Note: some molds need to be strong enough to strengthen the top part, plus strong pulling and strengthening mechanism, such as adding screw holes on the thimble plate.